Onkyo HT-R490 Speaker Setup, Sp Sel, Sw Mode Test Tone Ch Sel, VOLUME 5/∞ LEVEL 5/∞, Notes

Speaker Setup

	SP SEL	SW MODE
	DISPLAY				STEREO	/DTS	DSP
						SURROUND		MASTER VOLUME
STANDBY/ON				LISTENING MODE
STANDBY
POWER
ON	OFF							DIMMER
	SP SEL	SW MODE DIGITAL INPUT	FM MODE	MEMORY	TUNING	PRESET
A SPEAKERS B
			CLEAR

AUDIO	DVD	VIDEO 1	VIDEO 2	FM	AM	TAPE	C D
SELECTOR
			VCR				BASS	TREBLE

AV RECEIVER HT-R490

SW MODE

TEST TONE CH SEL

STANDBY/ ON SLEEP DIMMER DISPLAY

	INPUT SELECTOR
CD	TAPE		TUNER
D V D	VIDEO 1 VIDEO 2
			TUNER
SUR MODE SW MODE AUDIO SEL PRESET
	MODE		VCR
TV	CABLE SATELLITE
STANDBY/ ON	DVD	CD	TAPE
CH	TV VOL		CH
DISC			MUTING
TV/ VCR	TV VOL
TOP MENU	MENU
	E N T E R
		VOLUME
RETURN	SETUP
TEST TONE CH SEL		LEVEL
	T
REMOTE CON		ROLLER
	R C-44 6M

VOLUME 5/∞

LEVEL 5/∞

You need to set up the speaker configuration for the speaker system connected to the SPEAKERS A terminals (see page 17).

Notes:

•The speakers cannot be set up for optimum audio reproduction if the SPEAKERS B system is On (see page 7).

•It is not necessary to set up again once you have completed the setup unless you change the speaker configuration.

Note:

When the subwoofer mode is set to MODE 2 and audio is reproduced in the STEREO mode, the subwoofer may not output audio from certain sources (2 channel-Dolby Digital/DTS source etc.).

Selecting the speaker configuration

Press SP SEL button repeatedly to select the number of channels for the SPEAKERS A system.

When the button is pressed, the current speaker setup will be displayed for about 5 seconds. If you want to change it, press the same button again within the 5 seconds.

When the button is pressed repeatedly, the number of channels changes as follows:

Front left and right speakers

Front left, right, and center speakers

Front left and right, plus surround left and right speakers

Front left, right, and center, plus surround left and right speakers

Setting the subwoofer mode

Press SW MODE button repeatedly to select the subwoofer mode.

When the button is pressed, the current subwoofer mode will be displayed for about 5 seconds. If you want to change it, press the same button again within the 5 seconds.

When the button is pressed repeatedly, the subwoofer mode changes as follows:

When small-with limited bass signal handling-front speakers are connected

When large-wideband-front speakers are connected

Adjusting each speaker’s relative volume balance (Remote controller only)

Adjust each speaker’s relative volume balance so that the volume of all speaker’s test tones sound equal at the listening position.

1.Press the TEST TONE button.

Adjust the volume by gently increasing it with the VOLUME 5 button. Each speaker produces the test tone (pink noise) in the following order:

Front left speaker

Center speaker

Front right speaker

Surround right speaker

Surround left speaker

Subwoofer

2.To adjust the level of each speaker, press the CH SEL button to select a speaker and press the LEVEL 5/∞ buttons to raise or lower the level.

The test tone should sound at the same level when you hear it in your listening position. You can adjust the level in the range between –12 dB to +12 dB.

3.Press the TEST TONE button to complete adjustment.

When no subwoofer is connected

21