Using the Tuner
Listening to the Radio
| TUNING MODE | |
| TUNING |
|
| TUNING / PRESET | MASTER VOLUME |
STANDBY/ON |
|
|
| ENTER |
|
| STANDBY |
|
A SPEAKERS B | TONE+STEREO LISTENING MODEDISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN SETUP |
|
|
|
|
|
|
| CLEAR |
|
|
PHONES |
|
|
|
|
|
|
|
|
MULTl CH | DVD | VIDEO 1/VCR | VIDEO 2 | VIDEO 3 | TAPE | TUNER | CD |
|
|
|
|
|
| TUNER | SETUP |
With the
1 | Use the [TUNER] input selector | |
TUNER |
| |
| button to select either AM or FM. | |
| In this example, FM has been selected. | |
| Band | Frequency |
(Actual display depends on country.)
AM Frequency Step Setup
(not North America and Europe)
Here you can specify the AM frequency step used in your area. When this setting is changed, all radio presets are deleted.
1 | Press the [SETUP] button to dis- |
| |
| play “0. Hardware Setup,” and |
| then press [ENTER]. |
|
|
2 | Use the Up and Down [ ]/[ ] |
buttons to select “AM Freq,” and then use the Left and Right
[]/[ ] buttons to select:
10 kHz: Select if 10 kHz steps are used in your area.
9 kHz: Select if 9 kHz steps are used in your area.
3 | Press the [SETUP] button. |
| |
| Setup closes. |
Note:
•This procedure can also be performed on the remote controller by using its [SETUP] button, arrow buttons, and [ENTER] button.
Tuning into Radio Stations
■Auto Tuning Mode
1 TUNING MODE | Press the [TUNING MODE] button | |
so that the AUTO indicator | ||
| ||
| appears on the display. | |
2 | Press the TUNING Up or Down | |
| ||
TUNING / PRESET | [ ]/[ ] button. | |
| Searching stops when a station is | |
ENTER | found. |
■Manual Tuning Mode
1 | TUNING MODE | Press the [TUNING MODE] button | |
so that the AUTO indicator disap- | |||
|
|
pears from the display.
2 |
| Press and hold the TUNING Up or |
|
| |
| TUNING / PRESET | Down [ ]/[ ] button. |
|
| The frequency stops changing when |
| ENTER | you release the button. |
|
| |
|
| Press the buttons repeatedly to change |
|
| the frequency one step at a time. |
The American model changes FM frequency in 0.2 MHz steps, 10 kHz steps for AM. For other models it’s
0.05MHz steps for FM and 9 kHz or 10 kHz steps for
AM.
When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.
TUNED AUTO
FM STEREO
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.
Note:
• You can also use the remote controller’s Up and Down []/[ ] buttons to tune the radio.
38