Controlling Other Components—Continued
Remote Control Codes for Onkyo Components Connected via 
Onkyo components that are connected via 
can be controlled by pointing the remote controller at the AV receiver. This means that you can control such compo- nents even if they are out of sight, for example, installed in a rack.
1Make sure the Onkyo component is con-
nected with an 
cable and an analog audio cable (RCA).
See page 31 for details.
2Enter the appropriate remote control code for the [DVD] or [CD] REMOTE MODE but- ton.
[DVD] REMOTE MODE button 1612: DVD player with 
[CD] REMOTE MODE button
1327: CD player with 
1808: MD recorder with 
1322: CD recorder with 
See the previous page for information on entering remote control codes.
3Press the [DVD] or [CD] REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.
If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via 
, enter the following remote control codes:
[DVD] REMOTE MODE button
0627: DVD player without 
(default) [CD/MD/CDR] REMOTE MODE button
1817: CD player without 
(default)
0868: MD recorder without 
1323: CD recorder without 
Note:
If you connect an 
Resetting the REMOTE MODE Buttons
If you’ve previously entered a code for a REMOTE MODE button but now want to reset it, perform the fol- lowing procedure.
1While holding down the REMOTE MODE button that you want to
reset, press the [L NIGHT] button for 3 seconds.
The REMOTE MODE button lights up.
2Press the REMOTE MODE button again.
The REMOTE MODE button is reset and flashes twice.
The [DVD] and [CD] REMOTE MODE buttons are preprogrammed with remote control codes for control- ling Onkyo components. When one of these buttons is reset, the prepro- grammed code is restored.
Resetting the Remote Controller
You can reset the remote controller to its default settings.
1While holding down the
[RECEIVER] button, press the [L NIGHT] button for 3 seconds.
The [RECEIVER] button lights up.
2Press the [RECEIVER] button
again.
The remote controller is reset and the [RECEIVER] button flashes twice.
53
