Connecting the remote control cables
If your other components are made by ONKYO and those components are equipped with connectors, you can control the
Before connecting
•The unit must be connected in the system hookups for control operations.
•Each component has two connectors. There is no difference between these connectors.
•The components may be connected in any order.
•The hookups on the previous page are necessary independently of the system hookups.
The illustration below is an example of a hookup.
Connections
This unit
MD recorder
Stereo cassette
tape deck
Audio
CD recorder
CD player
remote control cable (supplied with every ONKYO component that has connectors except for the amplifier and receiver)
•This is not an example of stacking the components. For the example, refer to page 9.
AC outlet connection
You can connect the power cord from another audio device to the rear of the R- 805TX.
If the
ANTENNA |
| CDR | TAPE | L |
OUT | IN | OUT | IN | |
| L |
|
| L |
AM |
|
|
| CAUTION: |
R | R |
|
| SPEAKER |
| REMOTE |
| R | IMPEDANCE |
| CONTROL |
| ||
CD | OUT MD IN LINE/DVD PROCESSOR | SPEAKERS | 4 OHMS MIN. | |
|
|
|
| /SPEAKER |
L |
|
| L |
|
FM |
|
|
|
|
75 |
|
|
| AC OUTLET |
R |
|
| R | AC |
|
|
|
| 50Hz |
| OUT | IN |
| SWITCHED |
|
| 100W MAX. |
remote control cable to another Onkyo audio device that has a STANDBY/ON but-
ton, you can use the STANDBY/ON button
on the
device, or place both devices in standby mode. When the
placed in standby mode, electric current is always supplied to the AC connector on the rear panel. If you press the ENERGY SAVE button while the
The shape and capacity of the AC outlet may differ depending on the area of purchase. Make sure that the capacity of other components connected to this unit does not exceed the capacity that is printed on the rear panel.
15