Preparing the remote controller
Installing the remote controller batteries
1 Remove the battery compartment cover by pressing and sliding it away from the remote controller unit.
2 Insert two
Carefully follow the polarity diagram (positive + and negative - symbols) inside the battery compartment.
3 After batteries are installed and seated correctly, replace the compartment cover.
Notes
•Do not mix new batteries with old batter- ies or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller doesn’t operate smoothly, replace both the batteries at the same time.
•The life of the batteries supplied is about six months but this will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control sensor.
Remote control sensor
30˚ 
30˚
About 5 m (16 feet)
Control range
Notes
•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mis- take and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
21