Onkyo RC-391M manual Erasing a learned code from a Mode button

Programming the remote controller codes of other devices into the RC-391M

See page 39 for information on how to erase the learned codes from all buttons.

SEND/LEARN indicator

MODE buttons

Erasing a learned code

You can erase a learned code. You cannot erase preset codes.

•Erasing a code programmed in a button

1.Press and hold down the corresponding MODE button and press the ENT button, then release the buttons.

When you press the MODE button, the SEND/LEARN indica- tor lights up. When you press the ENT button, the indicator turns off. When you release the buttons, the indicator lights up again.

2.Press and release the button from which you wish to erase the learned code.

When you press the button, the SEND/LEARN indicator turns off. When you release the button, the indicator lights up again.

3.Press and release the same button again.

The SEND/LEARN indicator flashes twice slowly. The learned code is erased.

Note:

•If you do not press the button in step 2 or 3 for more than 30 sec- onds, the SEND/LEARN indicator flashes three times quickly, then the RC-391M exits Learning mode. Resume Step 1.

ENT

SEND/LEARN indicator

MODE buttons

ENT

Erasing a learned code from a MODE button

1.Press and hold down the MODE button from which you wish to erase the learned code, and press the ENT button twice. Then release the buttons.

When you press the MODE button, the SEND/LEARN indica- tor lights up. When you press the ENT button, the indicator turns off. When you release the buttons, the indicator flashes twice slowly, then lights up again.

2.Press and release the same MODE button again.

When you release the button, the SEND/LEARN indicator flashes twice slowly. The learned code is erased.

Note:

•If you do not press any button for more than 30 seconds, the SEND/LEARN indicator flashes three times quickly, then the RC-391M exits Learning mode. Resume Step 1.

•If you make a mistake during programming, the SEND/LEARN indicator flashes three times quickly, the RC-391M exits Learn- ing mode. Resume Step 1.

•If have programmed many button operations to a single MODE button, the SEND/LEARN indicator may remain illuminated continuously in Step 2. This is not malfunction.

35