Onkyo HTP-240 Getting to know Your Speaker Package, Subwoofer SKW-240, SKB-240, Front, Rear

HTP-240.fm Page 5 Wednesday, December 3, 2003 9:30 AM

Getting to know Your Speaker Package

Subwoofer (SKW-240)	Front, Center & Surround Speakers
	(SKF-240F, SKC-240C, SKM-240S,
■ Front	SKB-240)

1

■Rear

OUTPUT	LINE
LEVEL	INPUT

MIN MAX

23

To AC outlet

ASTANDBY/ON indicator

Red: Subwoofer in standby mode

Green: Subwoofer on

With the Auto Standby function, the SKW-240 automatically turns on when an input signal is detected in Standby mode. When there’s no input signal for about 20 minutes, the SKW-240 automat- ically enters Standby mode.

BOUTPUT LEVEL control

This control is used to adjust the volume of the sub- woofer.

CLINE INPUT

This RCA input should be connected to the sub- woofer preout on your DR-S2.2 DVD Receiver, amp, or other receiver with supplied RCA cable.

Note:

The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on your receiver or amp.

3

2

1

4

1Speaker terminals

These push terminals are for connecting the speaker to your DR-S2.2 DVD Receiver, amp, or other receiver with the supplied speaker cables. The sup- plied speaker cables are color-coded for easy identi- fication. Simply connect each cable to the same- colored positive speaker terminal.

2Keyhole slots

These keyhole slots can be used to wall-mount the speaker either horizontally or vertically.

3Speaker mount/bracket inserts

These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket.

Note:

Use commercially available 1/4-inch machine screws to attach the speaker to a speaker mount or bracket.

4Base/stand inserts (other than center speaker)

These threaded inserts can be used to mount the speaker on the supplied base (screws included) or an optional Onkyo speaker stand (AS-240).

5