Remote Control Codes for Onkyo Components Connected via u
Onkyo components that are connected via uare controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with an ucable and an analog audio cable (RCA).
See “Connecting Onkyo uComponents” for details
(➔ page 17).
2 Enter the appropriate remote control code for a REMOTE MODE button, by referring to the previous section.
`42157:
Onkyo cassette tape deck with u
`81993:
Onkyo Dock with u
3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.
Controlling Onkyo components without u
If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:
`30627:
Onkyo DVD player without u
`71817:
Onkyo CD player without u
`32900/33100/33500: Onkyo
`32901/33104/33504: Onkyo HD DVD player
`70868:
Onkyo MD recorder without u
`71323:
Onkyo CD recorder without u
`82990:
Onkyo Dock without u
En-56
Controlling Other Components
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default remote control code.
1 While holding down the REMOTE MODE button that you want to reset, press and hold down HOME until the remote indicator lights (about 3 seconds).
2 Within 30 seconds, press the REMOTE MODE button again.
The remote indicator flashes twice, indicating that the button has been reset.
Each REMOTE MODE button is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored.
Resetting the Remote Controller
You can reset the remote controller to its default settings.
1 | While holding down RECEIVER, press and hold |
| down HOME until the remote indicator lights |
| (about 3 seconds). |
2 | Within 30 seconds, press RECEIVER again. |
| The remote indicator flashes twice, indicating that the |
remote controller has been reset.