Setting the Incoming Digital Signal (Fixed Mode)
■Fixed Mode
`Off:
The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.
`PCM:
Only
`DTS:
Only DTS (but not
When “HDMI”, “COAXIAL” or “OPTICAL” is selected in the “Audio Selector” setting, you can then specify the signal type in “Fixed Mode”.
Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS.
•If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM.
•If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS.
Note
•The setting will be reset to “Off” when you change the setting in “Audio Selector”.
Listening Mode Preset
1 | 2 | 3 | 4 “Setup” 5 |
Main menu | Listening Mode Preset |
You can assign a default listening mode to each input source that will be selected automatically when you select each input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can select other listening modes during playback, but the mode specified here will be resumed once the AV receiver has been set to standby.
1 Use q/wto select the input source that you want to
set, and then press ENTER. The following menu appears.
| BD/DVD | |
Analog/PCM | Last Valid e r | |
Mono/Multiplex Source | Last Valid | |
2ch Source | Last Valid | |
Dolby D/Dolby D Plus/TrueHD | Last Valid | |
Last Valid | ||
Other Multich Source | Last Valid |
Default listening mode for analog and PCM sources.
En-63
Advanced Operations
2 Use q/wto select the signal format that you want to set, and then use e/rto select a listening mode.
Only listening modes that can be used with each input signal format can be selected (➔ pages 37 to 43). The “Last Valid” option means that the listening mode selected last will be used.
The “Straight Decode” option means that straight decoding listening mode (Dolby Digital, DTS, etc.) is selected.
Note
•For the “AM” or “FM” input selector, only “Analog” will be available.
•For the “NET” or “USB” input selector, only “Digital” will be available.
■Analog/PCM/Digital
With this setting, you can specify the listening mode used when an analog (CD, TV, LD, VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is played.
Note
•For the “AUX”, “EXTRA1”, and “EXTRA2” input selectors, only “PCM” is available.
■Mono/Multiplex Source
With this setting, you can specify the listening mode used when a mono digital audio signal is played (DVD, etc.).
■2ch Source
With this setting, you can specify the listening mode used when
■Dolby D/Dolby D Plus/TrueHD
With this setting, you can specify the listening mode used when Dolby Digital or Dolby Digital Plus format digital audio signals are played (DVD, etc.). Specifies the default listening mode for Dolby TrueHD sources, such as