Onkyo TX-NR808 instruction manual Enter

TV

d e f c a b

: Listening area a to f: Listening position

Note

•Make the room as quiet as possible. Background noise and Radio Frequency Interference (RFI) can disrupt the room measure- ments. Close windows, televisions, radios, air conditioners, flu- orescent lights, home appliances, light dimmers, or other devices. Turn off the cell phone (even if it is not in use) or place it away from all audio electronics.

•The microphone picks up test tones which played through each speaker as Audyssey MultEQ® Room Correction and Speaker Setup run.

•Audyssey MultEQ Room Correction and Speaker Setup cannot be performed while a pair of headphones is connected.

1Turn on the AV receiver and the connected TV. On the TV, select the input to which the AV receiver is connected.

2Set the speaker setup microphone at the Main Lis- tening Position a, and connect it to the SETUP

MIC jack.

SETUP MIC jack

Speaker setup microphone

The speaker setting menu appears.

3 When you’ve finished making the settings, press

ENTER.

MultEQ: Auto Setup
Speakers Type(Front)	Normal
Powered Zone2	Not Act
Subwoofer	Yes

•If your front speakers are bi-amped, you must select “Bi-Amp”in the “Speakers Type(Front)” setting (➔ 45). For hookup information, see “Bi- amping the Front Speakers” (➔ 15).

•If you change “Powered Zone2” setting, refer to “Setting the Powered Zone 2” for more details (➔ 71).

•If you are using a subwoofer(s), select “Yes” in the “Subwoofer” (➔ 46). If not, select “No” and skip step 4.

4 If you use a powered subwoofer(s), adjust the sub- woofer volume level to 75dB.

Test tones are played through the subwoofer. Use the volume control on the subwoofer.

Note

•If your subwoofer does not have a volume control, disre- gard the level displayed and press ENTER to proceed to the next step.

•If you set the subwoofer’s volume control to its maximum and the displayed level is lower than 75 dB, leave the sub- woofer’s volume control at its maximum and press ENTER to proceed to the next step.

5 Press ENTER.

Audyssey MultEQ Room Correction and Speaker Setup starts.

Test tones are played through each speaker as Audyssey MultEQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey MultEQ Room Correction and Speaker Setup, unless you want to cancel the setup.

6 Place the setup microphone at the next position, and then press ENTER.

Audyssey MultEQ performs more measurements. This takes a few minutes.

7	When prompted, repeat step 6.
8	Use q/wto select an option, and then press

ENTER.

MultEQ: Auto Setup
- -	Review Speaker Configuration - -
Subwoofer	Yes
Front	40Hz	TV
Center	40Hz
Surround	100Hz
Front Wide	None
Front High	100Hz
Surr Back	120Hz
Surr Back Ch	2ch

Save

Cancel

The options are:

`Save:

Save the calculated settings and exit

Audyssey MultEQ Room Correction and Speaker

Setup.

`Cancel:

Cancel Audyssey MultEQ Room Correction and

Speaker Setup.

Note

•You can view the calculated settings for the speaker con- figuration, speaker distances, and speaker levels by using e/r.

9 Disconnect the speaker setup microphone.

En

29