Connecting Your Speakers—Continued
Connecting Speaker
1 | Strip 3/8" (10 mm) of insu- | 3/8" (10 mm) |
| ||
| lation from the ends of the | |
|
| |
| speaker cables, and twist |
|
| the bare wires tightly, as |
|
| shown. |
|
2 While pressing the lever, insert |
| |
| the wire into the hole, and then |
|
| release the lever. |
|
| Make sure that the terminals are |
|
| gripping the bare wires, not the |
|
| insulation. |
|
Connecting a Powered Subwoofer
Using a suitable cable, connect the AV receiver’s SUB- WOOFER PRE OUT to an input on your powered sub- woofer, as shown. If your subwoofer is unpowered and you’re using an external amplifier, connect the SUB- WOOFER PRE OUT to an input on the amplifier.
Powered
subwoofer
LINE INPUT
Note:
Make sure the cable is plugged all the way.
The following illustration shows which speaker should be connected to each pair of terminals.
Front right | Front left |
speaker | speaker |
Speaker Set B
| Speaker Set A |
| |
| Center speaker |
|
|
Surround | Surround | Front right | Front left |
right | left | speaker | speaker |
speaker | speaker |
|
|
19
