Onkyo TX-SR574 Use the Down button to, Left and Right / but- tons to select Small, Large, or None

First Time Setup—Continued

6	Use the Down [ ] button to
	select “Surround,” and then use

the Left and Right []/[ ] but- tons to select Small, Large, or None.

Small: Select if the surround speak- ers are small.

Large: Select if the surround speak- ers are large.

None: Select if no surround speakers are connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

7	Use the Down [	] button to
	select “Surr Back,” and use the
	Left and Right [	]/[ ] buttons to
	select Small, Large, or None.

Small: Select if the surround back speakers are small.

Large: Select if the surround back

speakers are large.

None: Select if no surround back speakers are connected.

Notes:

•If the Surround setting in step 6 is set to None, this setting does not appear.

•If the Surround setting in step 6 is set to Small, the Large option cannot be selected.

8	Use the Down [ ] button to
	select “Surr Back Ch,” and use

the Left and Right []/[ ] but- tons to select 2ch or 1ch.

2ch: Select if two (left and right) surround back speakers are connected.

1ch: Select if one surround back

speaker is connected.

Note:

•If the Surround and Surr Back set- tings in steps 6 and 7 are set to None, this setting does not appear.

9	Press the [SETUP] button.
	Setup closes.
	SETUP

Testing the Speakers

To test that all of the speakers are working properly,

press the remote controller’s [TEST TONE] but- ton.

		LISTENING MODE
	STEREO	SURROUND
	AUDIO	SUBTITLE RANDOM		REPEAT
TEST TONE	TEST TONE	CH SEL	LEVEL-	LEVEL+
		PLAY MODE
	DISPLAY		L NIGHT	CINE FLTR
		VCR	DVD	HDD
		RC-647M

The test tone will be output by each speaker in turn and the name of each speaker will appear on the dis- play. To turn off the test tone, press the [TEST TONE] button again.

•If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, you may have wired the speakers incorrectly and you should check your connec- tions (see page 17).

•If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker configuration incorrectly (see page 35).

•Testing cannot be performed while speaker set B is on or a pair of headphones is connected.

36