Onkyo TX-SR574 instruction manual Advanced Setup, Speaker Distance, Speaker Levels

Advanced Setup—Continued

Speaker Distance

With these settings, you can specify the distance from each speaker to the listening position.

1		Measure and make a note of the
		distance from each speaker to
		the listening position.
2		Press the [RECEIVER] REMOTE
	RECEIVER	MODE button, followed by the
		[SETUP] button.
	SETUP
3		Use the Up and Down [ ]/[ ]
		buttons to select “3. SP Dis-

tance,” and then press [ENTER].

example, if the Front distance is set to 20 ft. (6 m), the Center and Subwoofer distances can be set between 15 and 25 ft. (4.5 and 7.5 m).

•The Surround and Surround Back distances can be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the Front distance. For example, if the Front distance is set to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back R, and Surr Back L distances can be set between 5 and 25 ft. (1.5 and 7.5 m).

Speaker Levels

You can set the volume level of each speaker so that all speakers can be heard equally at the listening position.

The speaker levels cannot be adjusted while a pair of headphones is connected, speaker set B is on, or the AV receiver is muted.

4	While “Unit” is displayed, use the
	Left and Right [ ]/[ ] buttons to
	select “feet” or “meters”.

feet: Distances can be set in feet. Range: 1 to 30 feet in 1-foot steps.

meters: Distances can be set in meters. Range: 0.3 to 9 meters in 0.3-meter steps.

5	Use the Down [	] button to
	select “Front,” and use the Left
	and Right [ ]/[	] buttons to

specify the distance for the front speakers, then press the Down [ ] button to select the next speaker.

6	Repeat step 5 for all speakers.
	Note:
	Speakers that you set to No or None in
	the Speaker Configuration (page 35)
	cannot be selected.
7	Press the [SETUP] button.
	Setup closes.

Notes:

•The Center and Subwoofer distances can be set up to 5 ft. (1.5 m) more or less than the Front distance. For

1		Press the [RECEIVER] REMOTE
	RECEIVER	MODE button, followed by the
		[SETUP] button.
	SETUP
2		Use the Up and Down [ ]/[ ]

buttons to select “4. Level Cal,” and then press [ENTER].

A pink noise test tone is output by the front left speaker.

3	Turn up the volume so that you
	can hear the test tone suffi-
	ciently.
	As each speaker outputs the test tone,
	its name appears on the display.

51