Manual No. 25-ULPNMU01-01

LPN1736 Omni-Directional Laser Scanner

Reset All Defaults

Opticon scanners are preprogrammed at the factory with default settings representing the settings most commonly used by our customers. In most applications, the scanner will work right out of the box without the need for additional programming. At any time, you can return a scanner to the factory defaults by scanning the “Start/Stop Programming Mode” bar code, then scanning the “Reset All Defaults - Wedge” programming bar code, followed by scanning the “Start/Stop Programming Mode” bar code again.

[[ ￿￿

Start/Stop Programming Mode

Scanning this programming bar code puts the scanner into the programming mode. The scanner will beep continuously indicating that it is in programming mode. In this mode the scanner will only read special programming bar codes. It will not read regular bar codes. Now you can scan the specific programming bar code(s) you desire. Finally scan the Start/Stop Programming again. This instructs the scanner to exit the programming mode. The beeps will stop. The scanner is now ready to read regular bar codes.

Keyboard Type Selection

VC ￿￿

Reset All Defaults to IBM AT Keyboard Wedge (UB)

The IBM AT style of keyboard is the default setting for this scanner. If your keyboard style is different scan the appropriate programming codes that follow:

Page 10