Manual No. 25-ULPNMU01-01

LPN1736 Omni-Directional Laser Scanner

4.Be sure the PC is in a program or application (for example, WordPad) that will accept input from the serial port.

Reset All Defaults -- RS-232

Our scanners are shipped with factory default settings that represent the settings most commonly used by our customers. In most applications, the scanner will work right out of the box without the need for additional programming.

At any time you can return the scanner back to the factory default settings by scanning the “Reset All Defaults -RS232” programming bar code. Remember that before scanning any programming codes, you must put the scanner into the programming mode by scanning the Start/Stop Programming Mode bar code. You must also scan this bar code, to exit the programming mode.

V3

(U2) Reset all Defaults

Reset All Defaults – RS232

You can also reset the scanner to the factory defaults by typing the following sequence on the keyboard (Esc) U2 (CR)

RS-232C Communication Parameters

Handshaking Protocol

Q1 ￿￿

No Handshaking (P0)

DEFAULT

Page 17