Optimus 120-1751 Installation, indicate polarity, Be sure to connect the wire from the amplifiers

Optimus 2-Way Truck Speakers		Faxback Doc. # 40069
(120-1751)	Installation
Note: Speaker wires are usually color-coded or otherwise marked to
indicate polarity.	Be sure to connect the wire from the amplifier's

+(positive) output to the speaker's + terminal, and the amplifier's - (negative) output to the speaker's - terminal. If you reverse these connections, bass response is greatly reduced.

Follow these steps to connect your speakers to your amplifier or equalizer/ booster.

1.Connect the amplifier to your stereo system as described in your amplifier and autosound system's owner's manuals.

2.Cut the speaker cable to the necessary length and separate the wires about 4 inches on each end.

3.Strip about 1/2 inch of insulation from the wire ends and twist the wire ends.

4.Connect the speaker wires to the amplifier's output terminals.

5.For each speaker wire, hold down one of the speaker's grooved INPUT terminal tabs and insert a speaker wire's bare end into the hole (connecting + to + and - to -). Then release the terminal tab.