6
I
nstalling the Remote
C
ontrol’s Batteries Your CD changer’s remote control requires two AA batteries (not supplied) for
power. We recommend alkaline batteries (RadioShack Cat. No. 23-552).
1. Press in the battery compartment cover’s latch and lift off the cover.
2. Put two fresh AA batteries into the compartment as indicated by the polar-
ity symbols (+ and –) marked inside.
3. Replace the cover.
Cautions:
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capaci-
ties.
• Always remove old or weak batteries. Batteries can leak chemicals that
can damage electronic circuits.
• If you do not plan to use the remote control for a month or more, remove
and store the batteries.
Note: If the remote’s range is reduced, replace the batteries immediately.
Using a Receiver’s Remote
C
ontrol with the CD Changer If your receiver/amplifier (such as most Optimus Professional Series receiver/
amplifiers) has an OSR mark, the receiver/amplifier’s remote can control som e
of the CD changer’s functions.
Plug one end of the supplied control cable into the CD changer’s CONTROL IN
jack. Plug the other end of the cable into the receiver/amplifier’s CONTROL OUT
jack.
Notes:
• This connection disables the CD changer’s infrared sensor. Aim the
remote control at the receiver/amplifier’s infrared sensor.
• You must also connect audio cables to your receiver for the receiver’s
remote control to operate your CD changer.
For details on connection and operation, refer to the receiver/amplifier’s owner’s
manual.