If you did not connect an input source to every jack or do not want to mix ev- ery input source connected to the mix- er’s input jacks, you do not need to follow all the steps in this section. Af- ter you decide which source(s) you want to preset and mix, use this table to determine which steps to follow.
To Preset | See Steps | |
|
|
|
|
|
|
Channel 1 | Phono 1 | |
|
|
|
| Line 1 | 5 |
|
|
|
Channel 2 | Phono 2 | |
|
|
|
| Line 2 | 10 |
|
|
|
Channel 3 | Line 3 | |
|
|
|
| Line 4 | 15 |
|
|
|
Notes:
•While you adjust the input signal levels for channels 1, 2, and 3, ei- ther use the headphones or turn up the receiver/amplifier’s volume to a comfortable listening level (not necessarily the final usable level).
•Do not play a quiet portion of mu- sic while you adjust the volume levels, otherwise the volume lev- els for channels 1, 2, and 3 will be overdriven during the loud por- tions of the music.
12
1.To preset the PHONO 1 input source, set PHONO 1/LINE 1 to
PHONO 1.
illustration of PHONO 1/LINE 1 set to PHONO 1
2.Start playback of the selected in- put source.
3.Slowly slide up the CH 1 volume level slide control until you get a reading of up to 0 on both VU meters.
illustration of CH 1 control
Important: Write down or remem- ber the CH 1 volume level slide control’s setting for the selected audio source, so each time you want to mix that source you can slide the CH 1 volume level slide control to the correct setting.
Note: If it was necessary to set the CH 1 volume level slide control all the way to 10 in order to get a reading of up to 0 on the VU meter, then slide CH 1 down to about 8 and rotate MASTER clock- wise until you get the reading of 0 on the VU meters.
