Optimus STAV-3690, 31-3040 owner manual Using the Remote Control

Using the Remote Control

Follow these steps to train the STAV-3690’s remote control.

1. Place both controls 1–2 inches apart with the windows facing each other.

1–2''

2.Select the AUDIO/VIDEO switch position. Set the switch to the position that best matches the function — to AUDIO for a CD player or tape deck or to VIDEO for a VCR or television.

3.Insert a pointed object (such as a straightened paper clip or the tip of a pen) into the LEARN hole on the STAV-3690’s remote control, then press and release. The TRANSMIT/ LEARN indicator flashes.

4.Within 1 minute, press the STAV-3690’s remote button you want to train. The TRANSMIT/LEARN indicator lights steadily.

5.Within 1 minute, hold down the other device’s remote control button that you want the STAV-3690’s remote to learn. The TRANSMIT/ LEARN indi- cator flashes.

If TRANSMIT/LEARN flashes twice, the signal might be too weak. Place the remote controls closer together and try again.

If TRANSMIT/LEARN repeatedly flashes, the remote control’s memory is full. Programming errors can fill memory. For example, fluorescent light, direct sunlight, the two remote controls being too far apart, or a low bat- tery might cause this error. Correct the error and try again.

6.Repeat Steps 4 and 5 to teach additional commands.

7.To exit the teaching mode, press LEARN or wait 1 minute.

To clear all learned commands from memory, press RECEIVER POWER, CD POW- ER, and TAPE/VCR POWER at the same time. The TRANSMIT/LEARN indicator flash- es four times.

26