Optoma Technology Single Chip DLP Projector specifications Powering Off the Projector

English

Installation

Powering Off the Projector

1.Press the “Power/Standby” button to turn off the projector lamp.

2.After pressing the “Power/Standby” button, you will see a message “Power off the lamp?” on the on-screen display. Press the “Power/Standby” button again to confirm. Other wise the message will disappear after 5 seconds.

3.“Power/Standby” indicator flashes red for about 2 minutes. The projector will automatically shut itself down.

If you want to turn on the projector, you must press the “Power/Standby”button within 2 minutes of the start of the indicator flashing.

4.Disconnect the power cord from the electrical outlet and the projector.

5.Do not turn on the projector immediately following a power off procedure.

vWhen the “TEMP” indicator flashes red for about 10 seconds, you will see a message “Fan Fail” on the on-screen display. After 5 seconds, the “Power/Standby” indicator flashes green for about 2 minutes and the projector will automatically shut itself down. Please contact your local reseller or service center.

vWhen the “TEMP” indicator lights solid red for about 10 seconds, it indicates the projector has been overheated. You will see a message “Over Temperature” on the on-screen display. After 5 seconds, the “Power/Standby” indicator flashes green for about 2 minutes and the projector will automatically shut itself down. Please contact your local reseller or service center.

vWhen the “LAMP” indicator lights solid orange and “Power/ Standby” indicator flashes green for about 2 minutes. The projec- tor will automatically shut itself down. Please contact your local reseller or service center.

11