Installation
Powering off the projector
1.Press the " " button on the remote control or " " button on the panel of the projector to turn off the projector. First push of button will display the following message on the screen.
Press the button again to confirm the shut down. If the button is not pressed, the message will disappear in 15 seconds.
2.The Power LED flashes green and the fans will speed up during shut down cooling cycle. The projector reaches
If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
" " button on the rear of the projector or " " on the remote control to restart the projector.
3.Disconnect the power cord from the electrical outlet and the projector only when the projector is in
Warning Indicator
▀■ When the Lamp LED indicator lights red, the projector will
| automatically shut itself down. Please contact your local |
Note | reseller or service center. See pages 40. |
|
Contact the nearest service center if the projector displays these symptoms. See page
54 for more information.
▀■ When the Temp LED is on a steady (not flashing) red, the projector will automatically shut itself down. Under normal conditions, the projector can be switched on again after it has cooled down. If the problem persists, you should contact your local dealer or our service center. See pages 40.
14