User Controls
Note
"IRE" is only supported on NTSC signal.
Automatic: Enable or disable Automatic to automatically select the appropriate settings.
Enabled - the projector will automatically select the appropriate settings.
Disabled - the projector won’t automatically select the appropriate settings.
Frequency: Change the display data frequency to match the frequency of your computer's graphic card. When you experience a vertical flickering bar, use this function to make an adjustment.
Phase: Synchronize the signal timing of the display with the
graphics card. If you experience an unstable or flickering image, use this function to correct it.
H Position: Adjust the horizontal position.
V Position: Adjust the vertical position.
White Level: Allow user to adjust White Level when inputting SVideo or Video/CVBS signals.
Black Level: Allow user to adjust Black Level when inputting SVideo or Video/CVBS signals.
Saturation: Adjust a video image from black and white to fully saturated color. Press the t to decrease the amount of color in
the image. Press the u to increase the amount of color in the image.
Hue: Adjust the color balance of red and green. Press the t
to increase the amount of green in the image. Press the u to increase the amount of red in the image.
IRE: Adjust measurement of composite video signals.
Black Level (for HDMI): Allows user to adjust the Black Level for HDMI signals.
Signal Power On
button.Off: Projector can only be turned on by pressing the "Power"
On:detected.Projector turns on automatically when an active signal is
36
