Appendices
The screws on the |
lamp cover and the |
1 
2 
lamp cannot be |
removed. |
The projector |
cannot be turned |
on if the lamp |
cover has not been |
placed back on the |
projector. |
Do not touch the |
glass area of the |
lamp. Hand oil can |
cause the lamp to |
shatter. Use a dry |
cloth to clean the |
lamp module if it |
was accidentally |
touched. |
3 
4
Lamp Replacement Procedure:
1.Switch off the power to the projector by pressing the “
” button.
2.Allow the projector to cool down for at least 30 minutes.
3.Disconnect the power cord.
4.Unscrew the two screws on the cover. 1
5.Lift up and remove the cover. 2
6.Unscrew the two screws on the lamp module. 3
7.Lift up the lamp handle and remove the lamp module slowly and carefully. 4 To replace the lamp module, reverse the previous steps.
8.Turn on the projector and use “Lamp Reset” after the lamp module is replaced.
Lamp Reset: (i) Press “Menu” (ii) Select “OPTIONS” (iii) Select “Lamp Settings” (iv) Select “Lamp Reset” (v) Select “Yes”.
English 54
