Oregon 613GC manual System CLEAN-UP

613GC OPERATOR’S MANUAL

OPERATION

SYSTEM CLEAN-UP

•After cutting, run the cut-off saw for at least 15 seconds with the water on to flush slurry and debris from diamond chain, guide bar and drive sprocket.

•Wash concrete slurry from cut-off saw assembly.

•Avoid getting any water in the carburetor or exhaust system. If water enters exhaust port, point the guide bar tip down and pull the starter handle several times to expel water from muffler.

•Remove guide bar and diamond chain. Flush out the chain tensioner with high water pressure and lube with grease.

•After cleaning the cut-off saw, spray the entire saw body, diamond chain, guide bar, and drive sprocket with a lightweight oil. Using lightweight oil on the cut-off saw will minimize rust and help reduce slurry build up.

15