Oregon ST275 Operating the TRIMMER/EDGER, Battery Pack and Charger, Connecting the Charger

OPERATING THE TRIMMER/EDGER	OREGON® Cordless Tool System
	TRIMMER/EDGER MODEL ST275

OPERATING THE TRIMMER/EDGER

BATTERY PACK AND CHARGER

WARNING: TO REDUCE THE RISK OF SHOCK, DO NOT CHARGE THE BATTERY PACK IN THE RAIN.

BATTERY PACK LED CHARGE-LEVEL INDICATOR

The lithium ion battery pack is equipped with an LED charge-level indicator. To test the charge level of the battery pack, press the indicator button on the battery pack’s face (Fig. 7).

No lights: recharge.

One steady green light: less than 25% charged.

Charge battery pack before use.

Two steady green lights: 26–50% charged.

Three steady green lights: 51–75% charged.

Four steady green lights: 76–100% charged.

FIG. 7

INDICATOR BUTTON

INDICATOR LIGHTS

CONNECTING THE CHARGER

If the charger includes a separate power cord, connect the charger cord to the charger and to the proper electrical outlet (Fig. 8).

FIG. 8

Only use the cord set that was supplied with the charger. At first use, verify that the plug type matches the receptacle.

CHARGER LED CHARGE-STATE INDICATOR

The battery charger is equipped with an LED charge-state indicator that indicates the state of charging as well as conditions that may delay or prevent charging (Fig. 9).

Note: Until a battery pack is inserted, no lights will be visible.

Blinking orange light: a fault condition exists. There are several potential causes. See “Troubleshooting” in this manual.

Steady orange light: the battery pack temperature is beyond the acceptable range (0°C/32°F to 40°C/104°F). Allow the battery pack to reach the acceptable temperature range before charging. The pack may be left on the charger as the temperature adjusts. Charging will begin when the proper temperature is reached.

FIG. 9

Blinking green light: battery pack is charging.

Steady green light: battery pack is ready for use.

18 AB 0214 - F/N 564571