![](/images/new-backgrounds/1214255/21425547x1.webp)
OREGON® Cordless Tool System | MAINTENANCE AND CLEANING | |
TRIMMER/EDGER MODEL ST275 | ||
| ||
|
|
•Remove the grass wrap protector from the trimmer head (Fig. 31).
FIG. 31
•Insert the new grass wrap protector.
•Remove the cover and the spool from the new trimmer head, as described in “Disassembling the trimmer head”.
•Place the new trimmer head, without the spool and cover, onto the spindle and turn clockwise two or three turns to start threading the trimmer head onto the spindle (Fig. 32).
FIG. 32
•Insert the screwdriver into the slot on the spindle.
•Hold the screwdriver steady to prevent the spindle from turning, then turn the trimmer head clockwise until it is hand tight.
•Reassemble the trimmer head as described in “Reassembling the trimmer head”.
•Load trimmer line as described in “Replacing trimmer line”.
SHARPENING THE LINE
CUTTING BLADE
It is recommended that an OREGON® Service Dealer sharpen the line cutting blade, but it can also be sharpened by the operator.
Line cutting blade sharpening requires a flat file.
After collecting the file, wear gloves and eye protection and remove the battery.
•Lay the trimmer on its side with the line cutting blade on top and face the bottom of the trimmer head (Fig. 33).
•Place the file against the cutting edge of the line cutting blade (1).
•Push the file down and to the right, removing material from the cutting edge (2).
FIG. 33 |
(2) |
(1) |
•Repeat until the line cutting blade is sharp.
AB 0214 - F/N 564571 | 27 |