Oregon Scientific BAR988HG user manual Turn Radio-Controlled Clock On / Off, Icon, Meaning

EN

RADIO-CONTROLLED CLOCK

The time and date are automatically updated by radio- controlled clock signals from official time-keeping organizations in Frankfurt (Germany) and Rugby (England) unless you disable this feature. The signals are collected by the remote sensor (RTGR328N) whenever it is within 1500 km (932 miles) of a signal.

Initial reception takes 2-10 minutes, and is initiated when you first set up the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking.

The icon shown in the Clock Area indicates

2factors:

•Connection between the main unit and the sensor that collects RF signals ( )

•RF signal reception ( )

How these signals work together:

ICON	MEANING
	The unit has contact with the
	sensor and has synchronized the
	time.
	The unit has contact with the
	sensor but the time has not been
	synchronized.

14

ICON	MEANING
	The unit has lost contact with the
	remote sensor but the time is
	synchronized.
	The unit has lost contact with the
	remote sensor and the time is not
	synchronized.
	The unit cannot reach the remote
	sensor.

NOTE To force a manual search for RF clock reception, press and hold SEARCH on the sensor (RTGR328N) for 2 seconds.

TURN RADIO-CONTROLLED CLOCK ON / OFF

If you wish to manually set the clock, you must first disable the radio-controlled feature. To do this, navigate to the Clock / Alarm Area. Then, press and hold DOWN on the main unit for 2 seconds. To enable it, navigate to the Clock / Alarm Area, then press and hold UP for 2 seconds.

RF clock enabled:

BAR988HG English R5 OP 14 8/20/04, 11:25 AM

Black