GB
Remote Unit
1.Locate the battery compartment at the back of the remote unit (→ p.6,E.).
2.Remove the screws on the battery compartment using a screwdriver (sold separately).
3.Insert two 1.5V alkaline AA batteries into the compartment, making sure to align the polarities correctly as shown by the diagram.
4.Replace the Battery Door onto the Battery Compartment and secure the screws.
UNIT CALIBRATION & RESET
Before you use this product, you must calibrate the unit to synchronize the transmission and reception of signals. It can also be used to reset all the functions of the unit to default settings, or in the case of discrepancies between the units values.
1.Place the remote unit next to the main unit.
2.Using a blunt stylus, press and hold the RESET Hole located at the back of the main unit (→ p.5,H.).
3.The main unit searches for remote signals soon after the reset. Typically the device will take up to four minutes to receive the signals.
8
GB
PLACEMENT OF UNITS
Position the remote unit and the main unit within the effective transmission range of 20 to 30 meters (65 to 100 feet). The NOTE effective range is greatly affected by building materials and where the units are positioned. Try various setups for the
best result.
Main Unit
You can either mount the main unit on a wall or make it stand on a flat surface.
Method | Instruction | Diagram |
Table Stand | The main unit is already equipped |
|
| with a |
|
| can support the unit on a flat |
|
| surface (→ p.5,K.). Simply pull out |
|
| the Table Stand and rest the main |
|
| unit on the surface. |
|
Wall Mount | The main unit can be mounted |
|
| onto a wall using a No. 6 screw |
|
| (3.0mm). |
|
| a) Position and nail the screw |
|
| into the place where you would |
|
| like to hang your main unit. |
|
| b) Leave ample space between |
|
| the wall and the screw head |
|
| while testing to make sure the |
|
| nail is secure. |
|
c)Fit the
9
EMR898_GB(02/05) | Page | 12/1/03, 10:36 AM Adobe PageMaker 6.5C/PPC |
