ACTIVATING / DEACTIVATING THE ALARM
To activate or deactivate the alarm:
1.Press the ALARM button.
2.Press the 
or 
button. When the alarm icon 
appears on the display, the alarm is activated. When the alarm icon does not appear on the display, the alarm is deactivated.
ALARM SOUND
When activated, the alarm icon flashes, the backlight will come on for 8 seconds and a beeping noise starts quietly. The alarm gradually becomes louder until it crescendos at 2 minutes.
TURNING THE ALARM SOUND OFF
To turn the alarm sound off and automatically activate it again after 24 hours, press any of the following buttons:
MODE
ALARM
UP
DOWN
CLOCK BACKLIGHT
TO MANUALLY TURN THE BACKLIGHT ON
Press the LIGHT button on the clock, and the backlight will turn on for 5 seconds.
TO ACTIVATE THE BACKLIGHT USING THE MOTION / LIGHT SENSOR
The clock backlight can be set up for a certain period of time to turn on for 10 seconds when a movement is detected in a dark room. Simply:
1.Press the ALARM button twice to get to the Backlight Setting Display.
2.Press and hold the ALARM button for 2 seconds to enter the Backlight Setting Mode.
3.The Code setting will flash.
4.Press the 
or 
buttons to change the setting. (Make sure you select the Code setting that matches the Code switch in the back of the nightlight).
5.Confirm the entry by pressing the ALARM button.
7
6.The Motion Start Hour will flash.
7.Repeat (4) and (5).
8.Continue the above procedures to set the Motion Stop Hour.
9.When the 
icon appears on the display, the function is activated. When the icon does not appear on the display, the function is deactivated.
NOTE Light ON – Press to turn the clock backlight ON for 10 seconds remotely.
NOTE The nightlight Clock Control switch must be set to On for this function to work.
TO ENABLE / DISABLE THE REMOTE-CONTROLLED CLOCK BACKLIGHT
1.Press the ALARM button twice to reach the display below.
2.Press the 
or 
buttons to change the setting to either:
|
| Enabled |
| OR | Disabled |
|
|
|
| |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NIGHTLIGHT
ACTIVATING THE NIGHTLIGHT USING THE MODE BUTTON
The nightlight can be activated independently to the clock unit. You can set the nightlight to the following options:
1.Nightlight On - When the room is dark the nightlight will stay on.
Slide the Mode button to On.
2.Nightlight Off - The nightlight stays off all the time.
Slide the Mode button to Off.
3.Nightlight Auto - When the nightlight detects motion in a dark room, it will light up for 20 seconds.
Slide the Mode button to Auto.
EN
JMR868A_EN_R6 | 7 | 09/21/2004, 11:08 |
