Oregon Scientific RMR603HGA Getting Started, REMOTE SENSOR THGR122NX, Batteries, Change Settings

EN

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries for the remote sensor.

Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.

NOTE Do not use rechargeable batteries.

shows when batteries are low.

UNIT	LOCATION
Main	Humidity Area when the
	INDOOR humidity is
	shown.
Remote	Humidity Area when the
	OUTDOOR humidity is
	shown.

6

CHANGE SETTINGS

1.Press and hold MODE for 2 seconds to enter setting mode.

2.Press UP or DOWN to change settings.

3.Press MODE to confirm.

TABLE STAND OR WALL MOUNT

Insert the stand on the back of the product, or mount it on a wall with a nail.

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo/ Hygro Sensor that collects Temperature and Humidity data. Data can be collected from up to 3 sensors. Additional sensors sold separately.

RMR603HGA lab test R2 6 1/17/04, 4:52 PM