To set the location:
1.Navigate to “Set Location” setting mode as shown in the Changing Settings section.
2.Select where you want to store the location e.g. C1.
3. Select the
the location is disabled.)
4.Select “Name” or “FIPS”.
•If you select “Name” you can select first the State and then the County of your chosen location, then press EXIT. (If you wish to receive
•If you select “FIPS” you need to enter the
NOTE If at step 2 you select “C0:All” you will receive all warnings within the unit’s reception range. This may result in giving you information for regions that are not relevant. The regions can be as large as 5,000 square miles (13 sq km). If you select
the ALL option and will only receive warnings from specified local areas.
NOTE Once the location name is selected, the corresponding FIPS code will be set into the memory. You cannot convert the code back to the location name. (FIPS is the Federal Information Processing System
9
number assigned to each State, or open waters in or around the US. The SAME code comprises of numbers generated by the FIPS system.)
ACTIVATE / DEACTIVATE LOCATION
You can activate / deactivate 1, some, or all of your stored locations.
When a location is activated,
the
be viewed in your stored
locations display.
When a location is
deactivated,
viewed in your stored
locations display.
To switch between activated or deactivated location status:
1.Navigate to “Set Location” setting mode as shown in the Changing Settings section.
2.Select a stored location e.g. C4 and press MENU. Then when “000000” or 
or 
to activate or deactivate it and press EXIT to confirm the setting.
EN
WR602_EN | 9 | 27/6/07, 12:58 PM |
