Cordless Handset Operation 15
Note:
When the keypad is locked, [ 
] key and [ INT ] key can be used to answer an external or intercom call.
Registration
Register new handsets on the eco50 base
The handsets which come in the same pack are already registered to the base. If you buy new handsets. You need to register them before use.
1.Charge the batteries (for 15 hours).
2.Register the handset (to the base unit).
Each base can register up to 5 handsets.
During standby mode,
1.Press and hold the [ 
\
] key for 3 seconds until both the [ 
] and [ 
] icons flash, then press and hold the
[ 
] key for 3 seconds. The following will appear on the display.
3.Enter the base pin code (0000). If the pin is wrong, the handset will restart searching for the base.
4.When the handset is registered, it will show “HS” followed by the handset number.
Note:
If the base is full and cannot add any more handsets, you will hear a tone. See the next section to remove a handset.
Remove handsets
During standby mode,
1.Press and hold the [ 
\
] key for 3 seconds, then press and hold the [ 
] key for 3 seconds.
2.Enter the default value 0000. If the pin is wrong, the handset will go back to standby.
3.Press the numeric keys
4.The unit will go back to standby if the removal is successful.
Note:
You can only remove other handsets in your system but you are not able to remove the handset you are using.
2. Press 1 and the handset begins to search for the base.
