You cannot program the base ringer if the handset has lost link with the base. UNAVAIL will be displayed.
Recall duration
When you are talking on the phone, pressing 
will send a flash signal. Recall settings are; Australia (Recall 1)100ms and New Zealand (Recall 2) 600ms. You should not need to change these settings.
Press 
PROG 
during standby and press 
until you see 
flashing.
1.Press 
OK 
to select. The current duration is now displayed.
2.Press 1 or 2 directly or press 
to select.
3.Press 
OK 
to confirm.
Register
Each handset can register to one base at a time only. The current base will be deregistered when a new base is registered.
Each base can register up to 4 handsets.
1.Press 
PROG 
during standby and press 
or 
until you see 
icon flashing.
2.Press 
OK 
to select.
3.Before you enter the PIN, press and hold 
on the base for 2 seconds until a registration tone is emitted. The base is now in the registration mode. (If the base is full and cannot take on any more handset, it will emit a reject tone instead. See the section of Deregister to delete a currently registered handset.)
4.Enter the PIN of the base and press 
OK 
.
You will hear a confirmation tone if the registration is successful. The handset label and the handset number will be displayed.
If the registration is not successful, you will see NOT REG on the handset. Follow the procedure and try again.
Deregister
A handset can deregister another handset registered to the same base. It cannot deregister itself.
1.Press 
PROG 
during standby follow by the 9 key.
2.Enter the handset number (i.e. HS#2) to delete. The LCD will display
3.Press 
OK 
and then
4.Enter the PIN
5.Press 
OK 
to confirm.
17
