4.While the radio is scanning, the scan icon will display and the radio will scroll through the channels.
5.When activity is detected on a channel, the radio will stop scanning and you will hear whatever transmissions are detected. The radio’s display will show the channel and CTCSS code on which activity was detected.
6.If you want to respond to the transmission, press 
within 5 seconds and you can respond.
7.The radio will resume scanning after 5 seconds of inactivity on the channel.
8.To stop scanning, briefly press and release
.
Scan advance
If scan stops on a channel that you don’t want to listen to, briefly press 
or 
to resume scanning for the next active channel.
Nuisance delete
If scan continuously stops on an undesired channel, press and hold 
or 
for at least 3 seconds, then release. This will temporarily remove the undesired channel from the scan list.
To restore the channel to the scan list, turn the radio off and then on. You cannot remove your home channel from the scan list (your home channel is the channel your radio was set to when you activated scan).
Keypad lock
Press and hold the 
button for three seconds to lock or unlock the keypad. When
the radio is locked, the 
icon will show in the display.
The keypad lock disables the 
, 
and 
buttons. It also disables the scan
function, but allows you to use the 
button to monitor the channel.
Call tone
A call tone alerts others in your group that you want to talk. Your radio has 10 call tones to choose from. Set the call tone to 0 to disable the function.
Selecting a call tone
1.With the radio on, press 
repeatedly, until 
appears in the display.
2.The current call tone setting will begin to flash.
3.Press
or 
to change and hear call tones while the setting number is flashing.
4.Press 
to set the new call tone.
Note:
1.The Australian UHF CB Radio Standard restricts tone calling to 3 seconds. This unit will only transmit for a maximum 3 seconds in any 60 seconds.
2.The radio does not support the call tone feature on channels 5 or 35.
15 | 16 |
