QUICK SET UP
USING YOUR TOUCH PHONE AND BASE
Earpiece/Receiver
End
Make sure your base is:
• Located within reach of a mains power socket and telephone socket.
• At least 1 metre away from other electrical appliances, to avoid interference.
• Not located in humid or damp conditions, e.g. in a bathroom.
1 Connect the base power lead and the telephone line cord to the back of the base. Plug the power adaptor into the mains wall socket.
2 For
3 On each handset: Slide the battery cover off and insert the batteries supplied following the markings shown inside the battery compartment, then slide the cover back on until it clicks into place.
4 Place the handsets in the base/charger handset cradle andmecharge for 15 hours before use.
5 Plug the telephone line cord into the wall socket.
Attaching the belt clip
With the back of the handset facing you, align the belt clip with the two slots on the side of the handset and push securely into place.
Your Oricom Touch phone is now ready for use
ATTENTION
Congratulations on your purchase of the Oricom Touch Phone with its high tech touch sensitive keypad. The touch panel is much more sensitive than a normal phone keypad and provides very fast and responsive keying - however like most new technology it takes a little getting used to.
To get the best use out of your Touch Phone
•Pick it up from the rear and cradle it in your hand.
•During use, avoid touching the keypad area unnecessarily to prevent accidental triggering of the keypad.
•The keypad will automatically disable when you hold the receiver to your ear. The idea being, to reduce the risk of accidental keypad presses while the phone is held against the side of your face.
Display
Display with icons and blue backlight.
Up/Down
Press during a call to increase/decrease earpiece volume. During standby use to scroll Up or Down through the menu options and through phonebook and Calls log entries.
Talk
Press to make and receive calls.
Redial/Pause 
Use to redial any of the last 20 numbers called. Press to enter a pause in a number.
Alphanumeric keypad 
Use to enter digits and characters.
*
When entering text, press repeatedly to enter punctuation.
Recall/Cancel 
For use with certain network services, including Call Waiting. Press to delete an incorrect character/digit. Press to return to previous menu.
Press to end calls. Press to exit the menu and return to standby mode.
Phonebook
Use to access the phonebook.
#/Conf
When entering text use to toggle between lower and upper case. Press to start a conference call.
Find Handset (page)
Press to page/locate a misplaced handset. (Located on the base behind the handset).
Menu/Mute
Press to access the menu or confirm a menu setting. During a call, press to mute the microphone.
INT
Use to call another registered handset.
In Use/Message
LED indicator
Illuminates when the line is in use. Flashes when you are connected to a switcboard and you have new voice messages.
