Basic settings

Basic settings

1.After installing the batteries, the display should flash the word

ENGLISH.

If not press and hold for approximately 4 seconds.

2.Select the desired language using or . Press DELETE/OK button.

3.Select the desired contrast setting (2=Default) using or . Press DELETE/OK button.

4.Set the month using or . Press DELETE/OK button.

5.Set the day using or . Press DELETE/OK button.

6.Set the hour (00-23) using or . Press DELETE/OK button.

7.Set the minute using or . Press DELETE/OK button.

Display(LCD)Contrast/Time Setting

If you wish to change the language, contrast, time settings at a later date, press and hold button for approximately 4 seconds and repeat steps 2-7 above.

Select country version

1.For New Zealand Select Recall = 600 on the switch on the rear side of the unit, New Zealand Recall/flash time is 600ms, the unit is now set up to insert 0/00 when receiving CID log in accordance with Telecom

NZ requirements. Or for Australia Select Recall = 100.

2.Lift and replace the handset to initialize.

NOTE:

If the switch is in the incorrect position Caller ID and the recall function will not operate correctly.

8

Page 10
Image 10
Oricom TP30 manual Basic settings, DisplayLCDContrast/Time Setting, Select country version