Oricom UHF2100 Call-Ringtone, Operation, Activating the Auto Channel Scan, Press the CALL button

Operation

Activating the Auto Channel Scan

Channel scan perform searches for active signals in an endless loop for all 40 channels, 38 CTCSS codes and all 83 DCS codes.

a. Press the MENU button 5 times, “SCAN” icon will display on LCD screen.

b. Press the UP or DOWN button to begin scanning channels when an active signal is detected, channel scan pauses on the active channel.

c. Press the MENU button six times, CTCSS flashes on the LCD screen press the UP or DOWN button to begin scanning the CTCSS from 1-38.

d. Press the MENU button seven times, DCS flashes on the LCD screen. Press the UP or DOWN button to begin scanning DCS code 1-83.

e. Press the PTT button to confirm your setting.

Vibrator and Call alert

Your radio can alert you to incoming signal by emitting an audible call tone and vibration signal.

Call-Ring tone

You can send a Call-ring tone to other radio users to give an alert that you want to communicate with them.

Press the CALL button

You will hear a ring tone for about two seconds; “TX” icon appears on the LCD screen. Any other units within the transmitting range and tuned to the same channel and sub- channel (if applicable) will hear the Call-ring tone.

15