AERIAL CONNECTIONS/POWER SOURCES
Connect an indoor or outdoor aerial to the aerial socket at the rear panel as shown below. For all aerial circuit problems, please consult your local dealer.
(A) INDOOR AERIAL
(B)
(A)
If an external aerial is not available, the telescopic aerial (supplied) may be used in areas of good TV reception. Adjust position for best reception.
(B) EXTERNAL AERIAL
The type of aerial required depends on the position of your home, its distance from the transmitter and local interference. If you do not have an aerial and you are uncertain of what to buy, you should seek the advice of a local aerial contractor.
OUTPUT • SORTIE
DIGITAL |
| RF IN | ON OFF |
AUDIO | COAXIAL |
| |
|
| MAIN POWER | |
ANALOGUE | L(G) |
|
|
AUDIO | SCART |
| |
|
|
| |
| R(D) | PRISE PERITEL |
|
Aerial socket
TO USE AC POWER
Use the AC line cord provided for operation on AC. Insert the AC cord plug into 240V 50Hz AC outlet.
Press MAIN POWER switch on the back panel, the red standby indicator will light. Turn on your unit by pressing Sub Power () on the front panel or on the remote control, the red standby indicator goes off.
TO USE DC POWER
By using the DC car cord supplied with the unit, you can operate this unit from a cigarette lighter socket in any car that utilizes a negative ground system.
The fused 12V DC car cord has been designed to power the set from the external DC power (12 volt negative ground) through the unit's DC input jack.
Connect the smaller plug on the end of the
CAR
To Cigarette
cord to the DC input jack on the rear of the unit, then insert the other end of the car cord into the cigarette lighter socket of your car. The red standby indicator will light.
It is not necessary to switch the main power switch to ON. Switch on your unit by pressing Sub Power () on the front panel or on the remote control, the red standby indicator goes off.
To DC Input Jack
OUTPUT • SORTIE
DIGITAL |
| RF IN | ON OFF |
AUDIO | COAXIAL |
| |
|
| MAIN POWER | |
ANALOGUE | L(G) |
|
|
AUDIO | SCART | Car Cord | |
|
| ||
| R(D) | PRISE PERITEL |
Lighter Socket
WARNING: Never watch the unit while driving the vehicle.
NOTES: • When the unit is not in use, always disconnect it from the car cigarette lighter socket to avoid a battery drain.
•Do not operate the unit if the car battery is weak. Peak current from the car alternator could blow the DC fuse.
•The unit will still consume Power when in STANDBY mode.
6