6 © 2007 directed electronics—all rights reserved
FULL FLUSH MOUNTING
Step 1: Determine where the tweeter will be mounted. Make sure there is a flat
area large enough for the tweeter and no obstructions behind the area.
Step 2: Using supplied template mark with a pen the hole needed for the tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing.
Step 4: Cut the hole for the tweeter. When using factory locations, this
step can be skipped. A hole can be cut either with a pair of metal tin
snips or a 2" hole saw for soft materials or 2-1/8" hole saw for hard materials.
WARNING: Check for clearance of window mechanisms and electrical wires
BEFORE you drill.
Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the
trim ring is flat with the front of the surface.
Step 8: Use the supplied pressure ring to secure the housing to the surface.
SURFACE
MOUNT
TRIM RING
FLUSH MOUNT
TWEETER
ASSEMBLY
MOUNTING
SCREWS
PRESSURE
RING
SURFACE
MOUNT
HOUSING
TWEETER TWEETER WIRE PANEL WIRING HARNESS