Rear Seat | Rear/Trunk |
| of Car |
Figure 2
Figura 2
Abbildung 2
STEP BY STEP INSTALLATION
Step 1: Determine where the speaker will be mounted.. Make sure there is a flat area large enough for the speaker to fit properly.. An uneven mounting surface can damage the driver..
Step 2: Check to make sure the space you have chosen for the speaker will not interfere with the operation of the vehicle..
Step 3: Using a template, mark the speaker hole with a pen..
Step 4: Cut the hole for the speaker.. When using factory locations, this step can be passed.. A hole can be cut either with a pair of metal tin snips or a hole saw corresponding to the size of the speaker listed below.. • 4 3/4" (120mm) hole saw (5 1/4")
• 5 1/2" (140mm) hole saw (6 1/2")
Step 5: Run the speaker wire to the speakers.. Make sure to keep wires away from sharp metal or other edges.. When passing through metal ,use a protective grommet..
Step 6: Using the template, mark the mounting holes with a pen..
Step 7:
Step 8: Pull the wire through the speaker opening and connect to the speaker..
Step 9: Mount the speaker and grill in the hole using the same screws.. Insert the screws through the grill and the mounting holes in the basket..
WARNING: Window mechanisms and electrical wires may be hidden from sight. CHECK FOR CLEARING BEFORE YOU DRILL!
4 | © 2009 directed |
