Orion Car Audio HCCA-D600 manual Amplifier Wiring, Remote Gain Operation, Speaker Connections

Remote Gain Operation

NOTE: Do not use the Remote Gain control when you have an expanded system installed (see Line Ouput Configurations). The Slave amplifier(s) gain will not be controlled.

The remote gain port provides easy remote access to the internal gain structure of the HCCA power amplifier. The RGC-1 plugs into the amplifier via the 1/8" mini jack plug. The RGC-1 can be installed in the front of the vehicle to control the amplifier gain level. The RGC-1 can be used as a bass level control when used on an amplifier dedicated to subwoofers.

AMPLIFIER WIRING

Power Connections for the HCCA-D600

●Orion Fuse Size: 1 x 30 AMP ATC

●Power connections accept up to 0 AWG wire.

●0/1 AWG power and ground wire recommended for optimal performance.

●Connect 12V+ to the battery through a fuse holder. This connection provides +12V main power to the amplifier.

●Power wire must be fused no more than 18" from battery.

●Ground amplifier to a good chassis ground as close as possible to the amplifier.

●Connect REM terminal to remote turn-on lead from source unit. This connection provides +12V power to turn-on the amplifier.

●Add extra ground wire between the negative terminal of the battery and the chassis.

NOTE: The addition of a ground wire from the battery to the chassis of the vehicle improves the ability of the battery to supply power to the amplifier. This is recom- mended because the current delivery of the factory electrical system was designed only to accommodate electronics supplied by the auto manufacturer.

Speaker Connections

The Orion HCCA-600D amplifier offer two positive and two negative output terminals for ease of connecting the speakers to the amplifier. Since this is a mono amplifier, the speak- er connectors are paralleled internally. The amplifier is stable to 1W.

MASTER SLAVE

© 2005 Directed Electronics—all rights reserved 11