Orion Car Audio HCCA1002 owner manual Installing the Tweeters, Surface Mounting

INSTALLING THE TWEETERS

SURFACE MOUNTING

Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location..

Step 2: Place the provided template or tweeter cup against the panel and mark the two holes at the rear of the housing..

Step 3: Drill the smaller holes using a 1/8" drill bit.. These are the mounting screw holes..

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill..

Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the speaker wire from the crossover through the grommet..

Step 5: After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover..

Step 6: Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting..

Step 7: Attach the housing using the supplied screws of the correct length for a solid mount..

Step 8: Insert the tweeter into the housing and attach the surface mount trim ring..

SURFACE	MOUNTING SCREWS
MOUNT
TRIM RING

SURFACE MOUNT HOUSING

Figure 1
Figura 1
Abbildung 1	TWEETER

TWEETER WIRE

PANEL WIRING HARNESS

4 © 2010 directed electronics—all rights reserved