Orion Car Audio HCCA1002 owner manual Full Flush Mounting, Figura Abbildung

FULL FLUSH MOUNTING

Step 1: Determine where the tweeter will be mounted.. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area..

Step 2: Using supplied template mark with a pen the hole needed for the tweeter..

Step 3: Be sure the hole is large enough for the tweeter housing..

Step 4: Cut the hole for the tweeter.. When using factory locations, this step can be skipped.. A hole can be cut either with a pair of metal tin snips or a 2" hole saw for soft materials or 2-1/8" hole saw for hard materials..

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill..

Step 5: Install tweeter in flush mount housing..

Step 6: Connect the speaker wires observing the correct polarity..

Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface..

Step 8: Use the supplied pressure ring to secure the housing to the surface..

FLUSH MOUNT
	TWEETER
	ASSEMBLY
FLUSH		TWEETER
MOUNT		CUP
TRIM RING

PRESSURE RING

Figure 2

Figura 2

Abbildung 2

TWEETER WIRE PANEL

WIRING HARNESS

© 2010 directed electronics—all rights reserved 5