Removing the Touch Pad, Removing the Main Board | Packard Bell C3

Removing the Touch Pad

To remove the touch pad, first remove the top cover (see Removing the Top Cover), then perform the following steps:

1. Unscrew the screws on the Top Cover as shown in Fig. 25

Fig. 25 Touch Pad screws

2. Carefully separate the Touch Pad module from the Top Cover.

Removing the Main Board

To remove the Main Board, first remove the Top Cover (see Removing Top Cover) then perform the following steps:

1. Remove the Hex screws from the VGA Port as shown in Fig. 26

Fig. 26 VGA Port

Packard Bell EasyNote C3 Disassembly Manual

M2x3 copper

Hex=M2.5x10

17

Image 17

Packard Bell C3 manual Removing the Touch Pad, Removing the Main Board

Contents

Packard Bell EasyNote C3 Disassembly Manual Table of contents Reassembly Instructions Disassembly InstructionsOverview Technician Notes Avoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the Memory Module Removing the Battery Removing the memory module Removing the Hard Disk Drive Removing the Keyboard Screws retaining the HDD assembly Disconnecting the keyboard flat cable Releasing the optical disk drive Removing the Optical Disk Drive Removing the screws retaining the Heat Plate Removing the LCD Module M2.5x7 silver Removing the rubber covers & screws on the LCD Module Removing the LCD Panel Removing the LCD Panel hinges Removing the CPU Unlocking the CPU Bottom cover screws Removing the Top Cover =M2.5x9 silver =M2.5x7 silver Removing the Main Board Removing the Touch Pad M2x4 silver Lifting up carefully the main board Removing the MDC Modem DIP Switch Settings Removing the Speaker Assembly Screws Dip Switches settings EasyNote C3 Disassembly Manual