Troubleshooting
26

Before calling for repair service, check the following items for possible remedies to an

encountered symptom.

Symptoms
No power
Check item
"Ghost" or double images
Check that the AC power cord is plugged into the mains socket.
Unplug the power cord, wait for 60 seconds. Then reinsert plug
into the mains socket and turn on the unit again.
This may be caused by obstruction to the antenna due to high rise buildings
or hills. Using a highly directional antenna may improve the picture.
No picture Check antenna connections at the rear of the unit to see if it is
properly connected to the unit.
Possible broadcast station trouble. Try another channel.
Adjust the contrast and brightness settings.
Select a correct input.
Is a non-compatible signal being input?
Good picture but no sound Increase the VOLUME.
Check that the unit is not muted.
Good sound but poor colour
Poor picture
Horizontal dotted line
Adjust the contrast, colour and brightness settings.
Sometimes, poor picture quality occurs when having activated an S-VHS
camera or camcorder connected and having connected another peripheral
at the same time. In this case, switch off one of the other peripherals.
Check whether the room is too bright.
This may be caused by electrical interference (e.g. hair dryer,
nearby neon lights, etc.)
Turn off the equipment.
Television not responding to
remote control Check whether the batteries are working. Replace if necessary.
Clean the remote control sensor lens on the unit.
Do not use the remote control under strong or fluorescent lighting.
The batteries should be inserted with polarity (+, -) aligned.
Snowy picture and noise Check the antenna connection.
No output from one
of the speakers
No stable or not
synchronised D-Sub picture
Adjust Balance in the SOUND (AUDIO) menu.
Check if you have selected the correct D-Sub mode in your PC.
Note:
If your problem is not solved, restart your TV by turning it off and then on again once.
Never attempt to repair a defective TV yourself.
Control buttons do not work Unplug the power cord, wait for some seconds. Then re-plug the
power cord and turn on the unit again.