Enabling remote logging 37
no logging remote enable command
The no logging remote enable command disables sending syslog
messages to a remote server. The syntax for the no logging remote
enable command is:
no logging remote enable
The no remote logging enable command is in the config command
mode.
The no remote logging enable command has no parameters or
variables.
logging remote address command
The logging remote address command sets the remote ser verfor
receiving the syslog messages; you enter the IP address of the server you
want. The syntax for the logging remote address command is:
logging remote address <A.B.C.D>
The logging remote address command is in the config command
mode.
Table10 "logging remote address command parameters and variables"
(page 37) describes the parameters and variables for the logging
remote address command.
Tabl e 10
logging remote address command parameters and variables
Parameters and
variables Description
<A.B.C.D> Specifies the IP address of the remote server in
dotted-decimal notation.
The default address is 0.0.0.0.
no logging remote address command
The no logging remote address command clears the IP address of
the remote server. The syntax for the no logging remote address
command is:
no logging remote address
The no logging remote address command is in the config command
mode.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.