TANDBERG Edge 75/85/95 MXP
202
The Advanced H.323 Settings only have an effect if they are supported by your IP infrastructure.
NAT
NAT, Network Address Translation, is used when a PC and a video communication system are
connected to a router with NAT support. NAT support in the video communication system enables
proper exchange of audio/video data when connected to an external video communication
system (when the IP traffic goes through a NAT router). When NAT is On, the NAT Server
Address will be shown in the startup-menu: "My IP Address: 10.0.2.1".
On The system will signal the configured "NAT Address" in place of its own IP-address
within Q.931 and H.245.
Auto The system will try to determine if the "NAT Address" or the real IP-address should
be used within signaling. This is done to make it possible to place calls to endpoints
on the LAN as well as endpoints on the WAN.
NAT Address
This must be the external/global IP-address to the router with NAT support. Packets sent to the
router will then be routed to the system. In the router, the following ports must be routed to the
system’s IP-address:
Port 1720
Port 5555-5560
Port 2326-2365
Please contact your TANDBERG representative for further information.
RSVP
Auto Resource Reservation Protocol enables the systems to request the optimal amount
of bandwidth for the duration of an IP videoconference.
Off Resource Reservation Protocol is switched off.
H.323 Ports
Static When selecting static H.323 ports for TCP connections the ports 5555 to 5574
will be used for Q.931 and H.245 respectively.
Dynamic The system will allocate which ports to use when opening a TCP connection.
The reason for doing this is to avoid using the same ports for subsequent calls
as some firewall consider this as a sign of attack.
When selecting Dynamic, the H.323 ports used are from 11000 to 65535. Once
65535 is reached they restart again at 11000.