Panasonic A66HY instruction manual Installation, Din Front/Rear-Mount

INSTALLATION

Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop.I

If installation angle exceeds 30° from horizontal, the unit might not give its optimum

performance. 30°

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.

Be sure to remove the front panel before installing the unit.

DIN FRONT/REAR-MOUNT

RCA LINE OUT JACK(OPTION)

This unit can be property installed either from “Front” (conventional DIN Front-mount) or “Rear”(DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods A and B.

DIN FRONT-MOUNT (Method A) Installation the unit

1

2

182

53

1. Dashboard

2. Holder

After inserting the half sleeve into the dashboard,

select the appropriate tab according to the

1

7

3

6

	thickness of the dashboard material and bend
	them inwards to secure the holder in place.
3. Screw
1.	Dashboard
2.	Nut (5mm)

4

2 5 3

Removing the unit

a

b

c

3.	Spring washer
4.	Screw (5x15mm)
5.	Screw
6.	Support Strap
	Be sure to use the support strap to secure the
	back of the unit in place. The strap can be bent by
	hand to the desired angle.
7.	Plain washer
a. Frame
b. Insert fingers into the groove in the front of frame
	and pull out to remove the frame. (When re-
	attaching the frame, point the side with a groove
	down wards and attach it.)
c. Insert the levers supplied with the unit into the
	grooves at both sides of the unit as shown in
	figure until they click. Pulling the levers makes it
	possible to remove the unit from the dashboard.

Trim Plate Installation:

Push the trim plate against the chassis until it is fitted.

You must do this before you install the front panel, otherwise it can't be attached.

E - 3