Panasonic AG-DVG7P manual Remote Controller, $ Inserting a Button-type Battery, 15˚ 15˚

The Remote Controller

$ Inserting a Button-type Battery

Before using the Remote Controller, insert the supplied button-type battery.

1 While pressing the Stopper 1, pull out the

Battery Holder.

1

2 Insert the button-type battery with the (+) marking facing upward.

3 Insert the Battery Holder into the Remote Controller.

OWhen the button-type battery is exhausted, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.)

OMake sure to match the poles correctly when inserting the battery.

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.

WARNING

Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 60°C or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

Before Use

$ Using the Remote Controller

1 Direct the Remote Controller to the Remote Control Sensor 3 of the Camera Recorder and press an appropriate button.

3

15˚ 15˚

15˚ 15˚

ODistance from the Camera Recorder:

Within approximately 5 metres

OAngle:

Within approximately 15° in the vertical and horizontal directions from the central axis

OThe above operative ranges are for indoor use. Outdoors or under strong light, the Camera Recorder may not operate properly even within the above ranges.

OWithin a 1-metre range, you can also use the Remote Controller on the LCD Monitor side of the Camera Recorder.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.

OIf the Remote Controller Mode of the Camera Recorder and that of the Remote Controller do not match, [REMOTE] Indication is displayed.

Setup on the Camera Recorder:

Set [REMOTE] on the [OTHER FUNCTIONS] Sub- Menu to the desired Remote Controller Mode. (-16-)

Setup on the Remote Controller:

STILL ADV	PAUSE	STILL ADV
2		1
INDEX	STOP	INDEX

SELECT

[VCR1]:

Press the [D] Button and [$] Button simultaneously. 1

[VCR2]:

Press the [E] Button and [$] Button simultaneously. 2

OWhen the battery in the Remote Controller is replaced, the mode is automatically reset to [VCR1] Mode.

11