Specifications
VTR Section
VTR Video System (during playback on a standard playback unit)
Bands: | Y; 30 Hz to 5.75 MHz o1.0 dB/p3.0 dB |
| PB, PR; 30 Hz to 2.75 MHz o1.0 dB/p3.0 dB |
S/N ratio: | Better than 55 dB |
K factor (2T pulse): | Within 2% |
Y/C delay: | Within 30ns |
VTR Audio System (during playback on a standard playback unit)
Sampling frequency: | 48 kHz (synchronized to video) |
Quantization: | 16 bits |
Frequency response: | 20 Hz to 20 kHzt1.0 dB (at reference level with OFF setting |
| for MIC LOWCUT on setting menu) |
Dynamic range: | 85 dB or more (at 1 kHz, AWTD) |
Distortion: | Within 0.1% (at 1 kHz, reference level) |
Wow & flutter: | Below measurable limit |
Head room: | 20 dB |
Emphasis: | T1r50 ¯s, T2r15 ¯s (can be turned ON/OFF) |
VTR Tape Travel System | |
Tape used: | DVCPRO format |
Tape speed: | 67.640 mm/sec (at 50 Mbps) |
| 33.820 mm/sec (at 25 Mbps) |
Recording/playback time: | Approx. 33 min. (at 50 Mbps, using |
| Approx. 66 min. (at 25 Mbps, using |
FF/REW time: | Approx. 3 min. (using |
Connectors |
|
Input |
|
AUDIO IN CH1/CH2 |
|
(XLR x2, 3 pins, female): | MIC/LINE switchable, balanced, more than 10 kilohms |
| MIC; Menu setting to p60, p50, p40 dBu |
| Phantom o48 V, ON/OFF switchable |
| LINE; Menu setting to p6, 0, o4 dBu |
MIC IN (XLR, 3 pins, female): | FRONT MIC; Phantom o48 V |
| REAR MIC; Phantom o48 V/o12 V (selectable using internal |
| switch), balanced, 3 kilohms Menu setting to p60, |
| p50, p40 dBu |
GENLOCK IN/ |
|
(VIDEO IN) (BNC): | 1.0 |
| recorded by menu selection) |
TIME CODE IN (BNC): | 0.5 V to 18 |
Output |
|
CAMERA OUT (BNC): | 1.0 |
VIDEO OUT (BNC): | 1.0 |
AUDIO OUT |
|
(XLR, 3 pins, male): | o4 dBu, balanced, low impedance CH1, CH2 or MIX |
| selectable |
TIME CODE OUT (BNC): | 1.5 |
PHONES (stereo mini jack·2) |
|
Other |
|
DC IN (XLR, 4 pins, male): | DC 12 V |
DC OUT (4 pins): | DC 12 V, 100 mA |
LENS (12 pins) |
|
ECU (6 pins) |
|
Accessories
Shoulder strap (q1), battery connector (including screws) for supporting Sony battery, AUDIO LEVEL CH1 control knob (including screw) (q1), Holder for an Anton Bauer battery (already mounted on main unit)
– 156 –